Datasheet

Absolute Maximum Ratings LM124-LM224-LM324
2/16
1 Absolute Maximum Ratings
Table 1. 15Key parameters and their absolute maximum ratings
Symbol Parameter LM124 LM224 LM324 Unit
VCC Supply voltage ±16 or 32 V
Vi Input Voltage -0.3 to Vcc + 0.3 V
V
id
Differential Input Voltage
(1)
1. Either or both input voltages must not exceed the magnitude of V
CC
+
or V
CC
-
.
-0.3 to Vcc + 0.3 V
P
tot
Power Dissipation
N Suffix
D Suffix
500 500
400
500
400
mW
Output Short-circuit Duration
(2)
2. Short-circuits from the output to VCC can cause excessive heating if V
CC
> 15V. The maximum output current
is approximately 40mA independent of the magnitude of V
CC
. Destructive dissipation can result from
simultaneous short-circuit on all amplifiers.
Infinite
I
in
Input Current
(3)
3. This input current only exists when the voltage at any of the input leads is driven negative. It is due to the
collector-base junction of the input PNP transistor becoming forward biased and thereby acting as input diodes
clamps. In addition to this diode action, there is also NPN parasitic action on the IC chip. this transistor action
can cause the output voltages of the op-amps to go to the V
CC
voltage level (or to ground for a large overdrive)
for the time duration than an input is driven negative.
This is not destructive and normal output will set up again for input voltage higher than -0.3V.
50 50 50 mA
T
oper
Operating Free-air Temperature Range -55 to +125 -40 to +105 0 to +70 °C
T
stg
Storage Temperature Range -65 to +150 °C
R
thja
Thermal Resistance Junction to Ambient
SO14
TSSOP14
DIP14
103
100
66
°C/W
ESD
HBM: Human Body Model
(4)
4. Human body model, 100pF discharged through a 1.5kΩ resistor into pin of device.
250
V
MM: Machine Model
(5)
5. Machine model ESD, a 200pF cap is charged to the specified voltage, then discharged directly into the IC with
no external series resistor (internal resistor < 5Ω), into pin to pin of device.
150
CDM: Charged Device Model 1500