Datasheet
Table Of Contents
- Figure 1. Block diagram
- 1 Description
- 2 Maximum ratings
- 3 Pin connection
- 4 Electrical characteristics
- 5 Typical electrical performance
- Figure 3. IC consumption vs. VCC
- Figure 4. IC consumption vs. TJ
- Figure 5. VCC Zener voltage vs. TJ
- Figure 6. Startup and UVLO vs. TJ
- Figure 7. Feedback reference vs. TJ
- Figure 8. E/A output clamp levels vs. TJ
- Figure 9. UVLO saturation vs. TJ
- Figure 10. OVP levels vs. TJ
- Figure 11. Inductor saturation threshold vs. TJ
- Figure 12. Vcs clamp vs. TJ
- Figure 13. ZCD sink/source capability vs. TJ
- Figure 14. ZCD clamp level vs. TJ
- Figure 15. R discharge vs. TJ
- Figure 16. Line drop detection threshold vs. TJ
- Figure 17. VMULTpk - VVFF dropout vs. TJ
- Figure 18. PFC_OK threshold vs. TJ
- Figure 19. PFC_OK FFD threshold vs. TJ
- Figure 20. Multiplier characteristics at VFF = 1 V
- Figure 21. Multiplier characteristics at VFF = 3 V
- Figure 22. Multiplier gain vs. TJ
- Figure 23. Gate drive clamp vs. TJ
- Figure 24. Gate drive output saturation vs. TJ
- Figure 25. Delay to output vs. TJ
- Figure 26. Start-up timer period vs. TJ
- 6 Application information
- 7 Application examples and ideas
- Figure 34. Demonstration board EVL6564-100W, wide-range mains: electrical schematic
- Figure 35. L6564 100W TM PFC: compliance to EN61000-3-2 standard
- Figure 36. L6564 100W TM PFC: compliance to JEITA-MITI standard
- Figure 37. L6564 100 W TM PFC: input current waveform at 230 - 50 Hz - 100 W load
- Figure 38. L6564 100W TM PFC: input current waveform at 100 V - 50 Hz - 100 W load
- 8 Package mechanical data
- 9 Order codes
- 10 Revision history

Revision history L6564
32/33 DocID16202 Rev 5
10 Revision history
Table 8. Document revision history
Date Revision Changes
08-Sep-2009 1 Initial release.
23-Dec-2010 2
Updated: Figure 1, Figure 19, Figure 27, Figure 29, Table 3,
Table 4, Table 5, Chapter 6.2, Chapter 6.3.
28-Sep-2011 3 Updated: Table 4, Chapter 6.3 and Table 6
20-Oct-2011 4 Updated: Chapter 7
12-Sep-2013 5
Corrected package name in Section 1: Description on page 5, titles
of Figure 39, Table 6 and Table 7, reversed order of Figure 39 and
Table 6 in Section 8: Package mechanical data on page 29.
Minor modifications throughout document.