Datasheet

Application ideas L5980
34/42 Doc ID 13003 Rev 6
6 Application ideas
6.1 Positive buck-boost
The L5980 can implement the step up/down converter with a positive output voltage.
Figure 33 shows the schematic: one power MOSFET and one Schottky diode are added to
the standard buck topology to provide 12 V output voltage with input voltage from 2.9 V to 18
V.
Figure 33. Positive buck-boost regulator
The relationship between input and output voltage is:
Equation 30
So the duty cycle is:
Equation 31
The output voltage isn’t limited by the maximum operating voltage of the device (18 V),
because the output voltage is sensed only through the resistor divider. The external power
MOSFET maximum drain to source voltage, must be higher than output voltage; the
maximum gate to source voltage must be higher than the input voltage (in Figure 33, if V
IN
is
higher than 16 V, the gate must be protected through zener diode and resistor)
The current flowing through the internal power MOSFET is transferred to the load only
during the OFF time, so according to the maximum DC switch current (0.7 A), the maximum
output current for the buck boost topology can be calculated from the following equation.
V
OUT
V
IN
D
1D–
-------------
⋅=
D
V
OUT
V
OUT
V
IN
+
------------------------------=