Datasheet

Electrical specifications L4995
8/35 Doc ID 13103 Rev 14
2 Electrical specifications
2.1 Absolute maximum ratings
Stressing the device above the rating listed in the “Absolute maximum ratings” table may
cause permanent damage to the device. These are stress ratings only and operation of the
device at these or any other conditions above those indicated in the Operating sections of
this specification is not implied. Exposure to Absolute Maximum Rating conditions for
extended periods may affect device reliability. Refer also to the STMicroelectronics SURE
Program and other relevant quality documents.
Table 3. Absolute maximum ratings
Symbol Parameter Value Unit
V
Vsdc
DC supply voltage - 0.3 to 40 V
I
Vsdc
Input current Internally limited
V
Vo
(1)
1. Using the typical application schematic with Cout= 10 µF and Iout=0 A, when the regulator is switched-on,
an overshoot exceeding 6 V could occur.This behavior does not impact the reliability of the regulator.
DC output voltage - 0.3 to 6 V
I
Vo
DC output current Internally limited
V
Wi
Watchdog input voltage -0.3 to V
Vo
+ 0.3 V
V
od
R
es
output voltage -0.3 to V
Vo
+ 0.3 V
I
od
R
es
output current Internally limited
V
cr
V
cr
voltage - 0.3 to V
Vo
+ 0.3 V
V
cw
Watchdog delay voltage - 0.3 to V
Vo
+ 0.3 V
V
En
Enable input - 0.3 to V
Vsdc
+0.3 V
T
j
Junction temperature - 40 to 150 C
V
ESD
ESD voltage level (HBM-MIL STD 883C) ± 2 kV
V
ESD
ESD voltage level (CDM AEC-Q100-011) 750 V