Datasheet

Doc ID 17414 Rev 5 5/9
HSP061-4NY8 Package information
Note: Product marking may be rotated by multiples of 90° for assembly plant differentiation. In no
case should this product marking be used to orient the component for its placement on a
PCB. Only pin 1 mark is to be used for this purpose.
Figure 11. µQFN-8L tape and reel specification
Figure 9. Footprint recommendations
(dimensions in mm)
Figure 10. Marking
.
.
.
.
According to IPC7351
0.4
1.4
1.8
0.4
0.2
0.55
H 4 N
Dot identifying Pin A1 location
User direction of unreeling
All dimensions are typical values in mm
4.0
4.0
2.0
8.0
1.75
3.5
Ø 1.55
0.63
1.17
0.22
2.17
H 4 N
H 4 N
H 4 N