Datasheet

Interrupt controller L6460
92/139 Doc ID 17713 Rev 1
Any event detection can be enabled and disabled by setting at logic level 1 the relative
enable bit in the interrupt controller configuration register (IntCrtlCfg).
The interrupt controller can be programmed to give a pulse when a monitored event
happens or to continuously maintaining the output active until the interrupt condition is
finished.
When programmed to signal the enabled events by giving pulses, the interrupt controller can
be configured to disable the event that caused the interrupt request until the firmware re-
enables it writing the relative bit in the control register (IntCrtlCtrl) or to continue to monitor
the event.
The GPIO output of this circuit can be programmed to be active high or active low.
WDWarn Watch dog warning event
WD Watch dog event
DigCmp Digital comparator
ADCDone1 ADC conversion done 1
(1)
ADCDone2 ADC conversion done 2
(1)
Vloop1Ilim AUX1 Ilimit event.
1. This event is disabled if the related ADC channel is configured in continuous mode.
Table 36. Interrupt controller event (continued)
Event Event description Notes