Datasheet

Board description EVAL6206Q
4/12 DocID023042 Rev 2
Table 2. Control board connector pinout (J2)
Pin Type Function
2 Ground Ground
3 Logic input Input IN1A of L6206Q
4 Logic input Input IN2A of L6206Q
5 Logic input Input IN1B of L6206Q
6 Logic input Input IN2B of L6206Q
11 Analog input Overcurrent threshold regulation for A bridge
12 Analog input Overcurrent threshold regulation for B bridge
13 Ground Ground
14 Supply voltage 3.3 V supply voltage
16 Logic input Input ENA of L6206Q
23 Ground Ground
24 Analog output Board identification system ID0
25 Analog output Board identification system ID1
27 Logic output Fault output for A bridge (OCDA output of L6206Q)
28 Ground Ground
29 Logic output Fault output for B bridge (OCDB output of L6206Q)
30 Logic input Input ENB of L6206Q
Others Unconnected
Table 3. Current sensing connector (J9)
Pin Type Function
1 Ground Ground
2 Analog output SENSEA pin of L6206Q
(1)
1. The R22/23 resistor and C12/13 capacitor must be added when output is used. The value of the RC
network should be chosen according to the target low-pass frequency of the filter.
3 Analog output SENSEB pin of L6206Q
(1)
4 Ground Ground