Datasheet
Table Of Contents
- Figure 1. EVAL6460 demonstration board
- 1 The L6460 main features
- 2 EVAL6460 board description
- 3 The EVAL6460 controlled by the EVAL_IBU-STR7
- Figure 5. EVAL_IBU-STR7 board
- Figure 6. EVAL_IBU-STR7 schematic board
- 3.1 Board connection and configuration
- 3.2 Starting flexSPIN evaluation software
- Figure 13. FlexSPIN evaluation software - start window
- 3.2.1 How to turn-on the VswDrv regulator
- 3.2.2 How to enable the DC1 and DC2 output bridges
- 3.2.3 How to enable the DC3 and DC4 output bridges
- 3.2.4 How to assign and read a GPIO
- 3.2.5 How to read and clear an undervoltage event
- 3.2.6 How to manage the interrupt controller
- 3.2.7 How to put the device into "low power" condition and awaken it
- 3.2.8 How to generate a PWM
- 3.2.9 How to close the low voltage power switch
- 3.2.10 How to measure an input voltage using A-D converter
- 3.2.11 How to use the digital comparator
- 3.2.12 How to configure and program the device via the SPI sequencer
- 3.2.13 How to read the device temperature
- 3.2.14 How to work in master - slave configuration
- 4 Revision history
The EVAL6460 controlled by the EVAL_IBU-STR7 AN3097
30/34 Doc ID 16599 Rev 2
Figure 35. FlexSPIN sequencer window
With this tool you can configure all device registers and program some command
sequences to drive the L6460.
● Button description:
– Browse: to set the file location to load
– Save as: to save a sequence. The default format for the sequences is "txt". The
sequence is saved in ASCII format and it can be modified with a text editor
– START: run the sequence. When the program is running the button label is
changed to STOP
– Insert statement: to add a row above the selected one
– Move up: to move the selected statement to the above position
– Move down: to move the selected row to the bottom position
– Remark on/off: to comment or uncomment a statement
– Remove statement: to delete the selected statement
– Remove all: to clear the window.