Datasheet
Table Of Contents
- Figure 1. EVAL6460 demonstration board
- 1 The L6460 main features
- 2 EVAL6460 board description
- 3 The EVAL6460 controlled by the EVAL_IBU-STR7
- Figure 5. EVAL_IBU-STR7 board
- Figure 6. EVAL_IBU-STR7 schematic board
- 3.1 Board connection and configuration
- 3.2 Starting flexSPIN evaluation software
- Figure 13. FlexSPIN evaluation software - start window
- 3.2.1 How to turn-on the VswDrv regulator
- 3.2.2 How to enable the DC1 and DC2 output bridges
- 3.2.3 How to enable the DC3 and DC4 output bridges
- 3.2.4 How to assign and read a GPIO
- 3.2.5 How to read and clear an undervoltage event
- 3.2.6 How to manage the interrupt controller
- 3.2.7 How to put the device into "low power" condition and awaken it
- 3.2.8 How to generate a PWM
- 3.2.9 How to close the low voltage power switch
- 3.2.10 How to measure an input voltage using A-D converter
- 3.2.11 How to use the digital comparator
- 3.2.12 How to configure and program the device via the SPI sequencer
- 3.2.13 How to read the device temperature
- 3.2.14 How to work in master - slave configuration
- 4 Revision history

The EVAL6460 controlled by the EVAL_IBU-STR7 AN3097
20/34 Doc ID 16599 Rev 2
Figure 20. Bridge 3 and 4 configuration
In this window you can set the use of bridges 3 and 4: the default configuration allows the
choosing of the output driving as mentioned for bridge 1 and 2. Clicking on one of the "Set
configuration and enable" buttons and then on the "PWM3 - PWM4" button, the following
window appears (Figure 21).
Figure 21. Bridge 3 and 4: PWM and operation mode selection