Datasheet
Table Of Contents
- Figure 1. EVAL6460 demonstration board
- 1 The L6460 main features
- 2 EVAL6460 board description
- 3 The EVAL6460 controlled by the EVAL_IBU-STR7
- Figure 5. EVAL_IBU-STR7 board
- Figure 6. EVAL_IBU-STR7 schematic board
- 3.1 Board connection and configuration
- 3.2 Starting flexSPIN evaluation software
- Figure 13. FlexSPIN evaluation software - start window
- 3.2.1 How to turn-on the VswDrv regulator
- 3.2.2 How to enable the DC1 and DC2 output bridges
- 3.2.3 How to enable the DC3 and DC4 output bridges
- 3.2.4 How to assign and read a GPIO
- 3.2.5 How to read and clear an undervoltage event
- 3.2.6 How to manage the interrupt controller
- 3.2.7 How to put the device into "low power" condition and awaken it
- 3.2.8 How to generate a PWM
- 3.2.9 How to close the low voltage power switch
- 3.2.10 How to measure an input voltage using A-D converter
- 3.2.11 How to use the digital comparator
- 3.2.12 How to configure and program the device via the SPI sequencer
- 3.2.13 How to read the device temperature
- 3.2.14 How to work in master - slave configuration
- 4 Revision history
AN3097 The EVAL6460 controlled by the EVAL_IBU-STR7
Doc ID 16599 Rev 2 13/34
3.1 Board connection and configuration
In this section the configuration of the EVAL6460 board, how to connect the board supply,
loads, and interface it to a PC through the EVAL_IBU-STR7 is shown.
3.1.1 Jumper configuration
1. Startup configuration (refer to the L6460 datasheet - startup configurations section).
Figure 7. Jumper startup configuration
All the jumpers are kept low: the single-device major mode is set.
2. Device ID
Figure 8. Jumper device ID
If more than one device is controlled, use these jumpers to identify them.