Datasheet
Table Of Contents
- Figure 1. EVAL6460 demonstration board
- 1 The L6460 main features
- 2 EVAL6460 board description
- 3 The EVAL6460 controlled by the EVAL_IBU-STR7
- Figure 5. EVAL_IBU-STR7 board
- Figure 6. EVAL_IBU-STR7 schematic board
- 3.1 Board connection and configuration
- 3.2 Starting flexSPIN evaluation software
- Figure 13. FlexSPIN evaluation software - start window
- 3.2.1 How to turn-on the VswDrv regulator
- 3.2.2 How to enable the DC1 and DC2 output bridges
- 3.2.3 How to enable the DC3 and DC4 output bridges
- 3.2.4 How to assign and read a GPIO
- 3.2.5 How to read and clear an undervoltage event
- 3.2.6 How to manage the interrupt controller
- 3.2.7 How to put the device into "low power" condition and awaken it
- 3.2.8 How to generate a PWM
- 3.2.9 How to close the low voltage power switch
- 3.2.10 How to measure an input voltage using A-D converter
- 3.2.11 How to use the digital comparator
- 3.2.12 How to configure and program the device via the SPI sequencer
- 3.2.13 How to read the device temperature
- 3.2.14 How to work in master - slave configuration
- 4 Revision history
AN3097 The EVAL6460 controlled by the EVAL_IBU-STR7
Doc ID 16599 Rev 2 11/34
3 The EVAL6460 controlled by the EVAL_IBU-STR7
The EVAL_IBU-STR7 is a control interface board dedicated to the EVAL6460 control; it
communicates with the PC and the flexSPIN evaluation software via a serial port (RS232).
The EVAL6460 is connected to the STR7 interface board via a standard 34-pin ribbon cable
interface.
The control interface board is based on the STR711FR2, an ARM-powered 32-bit
microcontroller with embedded high-speed single voltage Flash memory and high-speed
RAM. It combines the high performance ARM7TDMI CPU with an extensive range of
peripheral functions and enhanced I/O capabilities. The STR711FR2 has an embedded
ARM core and is therefore compatible with all ARM tools and software.
Figure 5. EVAL_IBU-STR7 board