Datasheet
Table Of Contents
- Figure 1. EVAL6460 demonstration board
- 1 The L6460 main features
- 2 EVAL6460 board description
- 3 The EVAL6460 controlled by the EVAL_IBU-STR7
- Figure 5. EVAL_IBU-STR7 board
- Figure 6. EVAL_IBU-STR7 schematic board
- 3.1 Board connection and configuration
- 3.2 Starting flexSPIN evaluation software
- Figure 13. FlexSPIN evaluation software - start window
- 3.2.1 How to turn-on the VswDrv regulator
- 3.2.2 How to enable the DC1 and DC2 output bridges
- 3.2.3 How to enable the DC3 and DC4 output bridges
- 3.2.4 How to assign and read a GPIO
- 3.2.5 How to read and clear an undervoltage event
- 3.2.6 How to manage the interrupt controller
- 3.2.7 How to put the device into "low power" condition and awaken it
- 3.2.8 How to generate a PWM
- 3.2.9 How to close the low voltage power switch
- 3.2.10 How to measure an input voltage using A-D converter
- 3.2.11 How to use the digital comparator
- 3.2.12 How to configure and program the device via the SPI sequencer
- 3.2.13 How to read the device temperature
- 3.2.14 How to work in master - slave configuration
- 4 Revision history
EVAL6460 board description AN3097
10/34 Doc ID 16599 Rev 2
Figure 3 and 4 show the component placement and the four-layer layout of the EVAL6460
demonstration board.
Figure 3. EVAL6460 component placement (top and bottom)
Figure 4. EVAL6460 layer layout
!-V
4O P
"OTTOM
!-V
,AYERTOP
,AYERINTERNAL
,AYERINTERNAL
,AYERBOTTOM