Datasheet

ESDALC12-1T2 Package information
Doc ID 15025 Rev 3 7/11
Note: Product marking may be rotated by multiples of 90° for assembly plant differentiation. In no
case should this product marking be used to orient the component for its placement on a
PCB. Only pin 1 mark is to be used for this purpose.
Figure 16. Tape and reel specifications
Figure 14. Footprint (dimensions in mm) Figure 15. Marking
0.55
(0.022)
0.40
(0.016)
0.50
0.020
0.55
(0.022)
N
Pin 2
N
Pin1
Pin 2
V
I
Cathode bar
User direction of unreeling
All dimensions in mm
4.0
2.0
8.0
2.0
1.75
3.5
Ø 1.55
0.6
0.68
0.20
1.10
N N N N N N N