Datasheet

STE100P
12/31
5 LP10H Link Partner’s 10Base-T Half Duplex ability.
0: link partner without 10Base-T ability.
1: link partner with 10Base-T ability.
0RO
4~0 LPSF Link partner select field. Default 00001=IEEE 802.3. 00001 RO
PR6- ANE, Auto-Negotiation expansion
15~5 --- Reserved 0 RO
4 PDF Parallel detection fault.
0: no fault detected.
1: a fault detected via parallel detection function.
0RO/LH*
3 LPNP Link Partner’s Next Page ability.
0: link partner without next page ability.
1: link partner with next page ability.
0RO
2 NP STE100P’s next Page ability.
Always 0, since STE100P without next page ability.
0RO
1 PR Page Received.
0: no new page has been received.
1: a new page has been received.
0RO/LH*
0 LPAN Link Partner Auto-Negotiation ability.
0: link partner has no Auto-Negotiation ability.
1: link partner has Auto-Negotiation ability.
0RO
LH = High Latching and cleared by reading.
PR17- XCIIS, XCVR Configuration information and Interrupt Status
15~10 ---- Reserved 0 RO
9 SPEED Configured information of Speed.
0: the speed is 10Mb/s.
1: the speed is 100Mb/s.
1RO
8 DUPLEX Configured information of Duplex.
0: the duplex mode is half.
1: the duplex mode is full.
0RO
7 PAUSE Configured information of PAUSE function for flow control.
0: PAUSE function is disabled.
1: PAUSE function is enabled
0RO
6 ANC Interrupt source of Auto-Negotiation Completed.
0: Auto-Negotiation has not completed yet.
1: Auto-Negotiation has completed.
0RO/LH*
5 RFD Interrupt source of Remote Fault Detected.
0: there is no remote fault detected.
1: remote fault is detected.
0RO/LH*
4 LS Interrupt source of Link Fail.
0: link test status is up.
1: link is down.
0RO/LH*
Table 5. Register Descriptions (continued)
Bit # Name Descriptions Default Val RW Type