Data Sheet

BLUENRG-M2Sx
17
8.2.1.a
Modular approval
IC: 8976C-BNRGM2SA and 8976C-BNRGM2SP
In accordance with IC RSS-247, the BLUENRG-M2Sx is listed as a modular transmitter
device.
This module is evaluated for stand-alone use only. Finished products incorporating
multiple transmitters must comply with colocation and RF exposure requirements in
accordance with IC multi-transmitter product procedures. Collocated transmitters
operating in portable RF Exposure conditions (e.g. <20cm from persons including but
not limited to body worn and hand held devices) may require separate approval.
Labeling instructions for the BLUENRG-M2SA
When integrating the BLUENRG-M2SA into the final product, the OEM must ensure that
the IC labeling requirements are satisfied. A statement must be included on the exterior
of the final product which indicates that the product includes a certified module. The label
should state the following (or similar wording that conveys the same meaning):
Contains IC: 8976C-BNRGM2SA
OR
This product contains IC: 8976C-BNRGM2SA
The OEM must include the following statements on the exterior of the final product
unless the product is too small (e.g. less than 4 x 4 inches)
Labeling instructions for the BLUENRG-M2SP
8.2.1.b
When integrating the BLUENRG-M2SP into the final product, the OEM must ensure that the IC
labeling requirements are satisfied. A statement must be included on the exterior of the final
product which indicates that the product includes a certified module. The label should state the
following (or similar wording that conveys the same meaning):
Contains IC: 8976C-BNRGM2SP
OR
This product contains IC: 8976C-BNRGM2SP
The OEM must include the following statements on the exterior of the final product unless the
product is too small (e.g. less than 4 x 4 inches)