Data Sheet

BLUENRG-M2Sx
15
8
8.1
Regulatory compliance
FCC certification
This module has been tested and found to comply with the FCC part 15 rules. These
limits are designed to provide reasonable protection against harmful interference in
approved installations. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference may not occur in a particular installation.
This device complies with part 15 of the FCC rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that
may cause undesired operation.
Modifications or changes to this equipment not expressly approved by
STMicroelectronics may render void the user's authority to operate this equipment.
In addition, the RF exposure compliance distance of the BLUENRG-M2SP is set equal to
5 mm, as shown in the following Tables.
8.1.1.a
Modular approval
FCC ID: S9NBNRGM2SA & S9NBNRGM2SP
In accordance with FCC part 15, the BLUENRG-M2SA & BLUENRG-M2SP is listed as a
modular transmitter device.
This module is evaluated for stand-alone use only. Finished products incorporating
multiple transmitters must comply with colocation and RF exposure requirements in
accordance with FCC multi-transmitter product procedures. Collocated transmitters
operating in portable RF Exposure conditions (e.g. <20 cm from persons including but not
limited to body worn and hand held devices) may require separate approval.
Labeling instructions for BLUENRG-M2SA
When integrating the BLUENRG-M2SA into the final product, the OEM must ensure that
the FCC labeling requirements are satisfied. A statement must be included on the exterior
of the final product which indicates the product includes a certified module. The label
should state the following (or similar wording that conveys the same meaning):
Contains FCC ID: S9NBNRGM2SA
OR
This product contains FCC ID: S9NBNRGM2SA
The OEM must include the following statements on the exterior of the final product unless
the product is too small (e.g. less than 4 x 4 inches):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including any interference that may
cause undesired operation.