Data Sheet

BlueNRG-M2SA
32 Rev 0
.1 P a g e | 19
6.2
IC certification
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject
to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
6.2.1
Modular approval
IC: 8976C-BNRGM2SA
In accordance with IC RSS-247, the BLUENRG-M2SA is listed as a modular transmitter
device.
This module is evaluated for stand-alone use only. Finished products incorporating
multiple transmitters must comply with colocation and RF exposure requirements in
accordance with IC multi-transmitter product procedures. Collocated transmitters
operating in portable RF Exposure conditions (e.g. <20cm from persons including but not
limited to body worn and hand held devices) may require separate approval.
Labeling instructions
When integrating the BLUENRG-M2SA into the final product, the OEM must ensure that
the IC labeling requirements are satisfied. A statement must be included on the exterior of
the final product which indicates that the product includes a certified module. The label
should state the following (or similar wording that conveys the same meaning):
Contains IC: 8976C-BNRGM2SA
OR
This product contains IC: 8976C-BNRGM2SA
The OEM must include the following statements on the exterior of the final product unless
the product is too small (e.g. less than 4 x 4 inches):
This device complies with RSS-247 of the IC Rules. Operation is subject to the following
two conditions:
1. this device may not cause harmful interference, and
In addition, accordingly to RSS-102 clause 2.6, the RF exposure compliance distance
of the BLUENRG-M2SA is set equal to 15 mm, as shown in the following Tables.