Data Sheet

BlueNRG-M2SA
Rev 0.
1 P a g e | 17 32
6
6.1
Regulatory compliance
FCC certification
This module has been tested and found to comply with the FCC part 15 rules. These limits
are designed to provide reasonable protection against harmful interference in approved
installations. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference may not occur in a particular installation.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause
undesired operation.
6.1.1
Modifications or changes to this equipment not expressly approved by STMicroelectronics
may render void the user's authority to operate this equipment.
In addition, the RF exposure compliance distance of the BLUENRG-M2SA is set equal to
15 mm, as shown in the following Tables.
Modular approval
FCC ID: S9NBNRGM2SA
In accordance with FCC part 15, the BLUENRG-M2SA is listed as a modular transmitter
device.
This module is evaluated for stand-alone use only. Finished products incorporating multiple
transmitters must comply with colocation and RF exposure requirements in accordance
with FCC multi-transmitter product procedures. Collocated transmitters operating in
portable RF Exposure conditions (e.g. <20 cm from persons including but not limited to
body worn and hand held devices) may require separate approval.
Labeling instructions
When integrating the BLUENRG-M2SA into the final product, the OEM must ensure that
the FCC labeling requirements are satisfied. A statement must be included on the exterior
of the final product which indicates the product includes a certified module. The label
should state the following (or similar wording that conveys the same meaning):
Contains FCC ID: S9NBNRGM2SA
OR
This product contains FCC ID: S9NBNRGM2SA
The OEM must include the following statements on the exterior of the final product unless
the product is too small (e.g. less than 4 x 4 inches):
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: