Data Sheet

Figure 21. UKCA certification logo
12.4 FCC certification
The STM32WB5MMG module complies with part 15 of the FCC Rules.
The FCC ID is YCP-STM32WB5M001 for version Y, and YCP-32WB5MMGH02 for version X.
The module label includes the corresponding FCC ID.
The operation is subject to the following two conditions:
• This device may not cause harmful interference
• This device must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation.
Label requirements
If the identification number is not visible when the module is installed inside another device, then the outside of
the device into which the module is installed must also display a label referring to the enclosed module. This label
must contain the FCC ID that matches the one on the module.
RF radiation exposure statement caution
The module antenna must be installed to meet the RF exposure compliance separation distance of “20 cm” and
any additional testing and authorization processes as required.
Documentation requirements
The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that
changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
Integration requirements
Co-location of this module with other transmitters that operate simultaneously are required to be evaluated using
the multi-transmitter procedures.
The host integrator must follow the integration instructions provided in this document and ensure that the
composite-system end product complies with the requirements by a technical assessment or evaluation to the
rules and to KDB Publication 996369.
The host integrator installing this module into their product must ensure that the final composite product complies
with the requirements by a technical assessment or evaluation to the rules, including the transmitter operation and
should refer to guidance in KDB 996369.
12.5
ISED certification
The STM32WB5MMG module has been tested and found compliant with the ISED RSS-247 and RSS-Gen rules.
The IC ID is 8976A-STM32WB5M01 for version Y and 8976A-32WB5MMGH02 for version X .
STM32WB5MMG
FCC certification
DS13252 - Rev 3
page 31/41