Installation Guide

ManualsBrandsStinger ManualsAmp Accessories & Installation PartsStinger - 2/4 Channel Universal Amplifier Installation Kit for Harley-Davidson - Black

Tech Support: 800-477-2267

Stinger is a Power Brand of AAMP Global

stingerelectronnics.com aampglobal.com

POWER

SPORTS

POWER SPORTS

MADE FOR HARLEY-DAVIDSON

SVTK4681

SVTK4681 AMPLIFIER INSTALLATION KIT

HD CRUSIER INSTALLATION MANUAL

STEP 1 - With the ignition switch off, remove the seat.

WARNING: Keep the ignition switch off throughout the entire installation process.

Refer to manufacturer instructions if necessary.

Disconnect the negative (–) side of the battery, followed by the positive (+) side.

WARNING: Be sure to prevent the loose battery cables from contacting the exposed battery terminals accidentally

during the installation process.

Summary of content (6 pages)

PAGE 1
MADE FOR HARLEY-DAVIDSON POWER SPORTS SVTK4681 SVTK4681 AMPLIFIER INSTALLATION KIT HD CRUSIER INSTALLATION MANUAL STEP 1 - With the ignition switch off, remove the seat. WARNING: Keep the ignition switch off throughout the entire installation process. Refer to manufacturer instructions if necessary. Disconnect the negative (–) side of the battery, followed by the positive (+) side.
PAGE 2
MADE FOR HARLEY-DAVIDSON POWER SPORTS SVTK4681 STEP 2 - Carefully remove the front fairing cover, noting which hole each screw comes from, as lengths and sizes may differ. Tech Support: 800-477-2267 Stinger is a Power Brand of AAMP Global stingerelectronnics.com aampglobal.
PAGE 3
MADE FOR HARLEY-DAVIDSON POWER SPORTS SVTK4681 STEP 3 - Determine the mounting location for the amplifier based on your fairing. Route and connect the power wire (without the in-line fuse installed) from the Positive (+) battery terminal under the right side (passenger, starboard, Etc.) Of the gas tank, through the fairing, and to the main amplifier terminal labeled pwr. The black sleeve should end up covering the exposed power wire between the gas tank and the fairing.
PAGE 4
MADE FOR HARLEY-DAVIDSON POWER SPORTS SVTK4681 STEP 4 - Batwing fairings (Street Glide / Electra Glide) Mount the main amplifier on top of the source unit using one of these methods: 2005 and older - use the large velcro® patch provided. 2006 and newer - cut the large velcro® patch in half and choose the appropriate method below: With both factory XM® and CB modules installed above the source unit, use the two patch halves, one on each module.
PAGE 5
MADE FOR HARLEY-DAVIDSON POWER SPORTS SVTK4681 Step 6a - For all “top of the source unit” installations, ensure that the main amplifier is positioned as far back towards the inner fairing as possible, leaving just enough room for the speaker wiring and control cables as needed. Warning: do not install the in-line fuse until instructed to do so. Note: On 2006 and newer, we recommend utilizing the factory wiring harness channel under the tank with a suitable wire feeding tool or device.
PAGE 6
MADE FOR HARLEY-DAVIDSON POWER SPORTS SVTK4681 STEP 7 (optional) - Replace the factory speakers with 4 ohm aftermarket speakers (for 1998-2013 HD models 6.5” speaker adaption use PAC-Audio.com / BestKits.com part number BKHSB200 (sold separately).