Installation Guide

SPXRGBC

SMART RGB LED CONTROLLER

SPECIFICATIONS

•APP: EZ LED (iOS and Android)

•Operating temperature: -20~80°C

•Voltage: DC12V/24V,

•Distance: 10-20M

•Maximum output current: 10A

•Outputs: 4

NOTE: Do not exceed 10 AMPS

total across all 4 outputs.

Universal, waterproof, RGB controller with Bluetooth Control.

Before you start, review directions completely. If your vehi-

cle is not pre-wired for accessory lighting, you may need a

switch and relay.

SPXRGBC

Black - Ground

Red - Battery (12V+)

Blue - Remote In (12V+)

AMP

FUSE

Optional SPXRGBMF Solder Connector

Connect to optional to SPXRGB5 Universal

RGB LED Strip Lights

PAGE 1
SPXRGBC SMART RGB LED CONTROLLER Universal, waterproof, RGB controller with Bluetooth Control. Before you start, review directions completely. If your vehicle is not pre-wired for accessory lighting, you may need a switch and relay.
PAGE 2
SPXRGBC SMART RGB LED CONTROLLER (CONT) WIRING DIAGRAM The SPXRGBC can be wired to a switch or to accessory power using the BLUE lead. The RED wire should be connected to constant power to save the RGB light settings. Connect BLACK wire to Ground. SPXRGBC Black - Ground NOTE: Do not connect the Red and BLUE to constant power and use the app to turn the module on and off. The module will draw power even when turned off with the app.