User's Guide

ManualsBrandsStinger ManualsAV PlayersMedia Player (Bluetooth)

Table Of Contents

空白页面

SPXM1

Marine Digital Media Receiver

Installation Guide

FCC ID:2ATYS-SPXM1

IC:10801A-SPXM1

Visit StingerElectronics.com for

User Guide | Updates | Tech Tips

Be sure to read this installation manual thoroughly before carrying

out installation and making connections. Installation of this product

requires technical skill and experience. It is recommended to have it

professionally installed by an authorized Stinger or Phoenix Gold

Dealer.

Summary of content (6 pages)

PAGE 1
SPXM1 Marine Digital Media Receiver Installation Guide FCC ID:2ATYS-SPXM1 IC:10801A-SPXM1 Be sure to read this installation manual thoroughly before carrying out installation and making connections. Installation of this product requires technical skill and experience. It is recommended to have it professionally installed by an authorized Stinger or Phoenix Gold Dealer. Visit StingerElectronics.
PAGE 2
PRECAUTIONS Parts List Disconnect the vehicle's negative battery cable before making any wire connections. Protect all vehicle surfaces with tape or plastic. Do not install components in any location that will hinder vehicle operation, such as steering wheel, gearshift, air bags, hazard switch. Bundle cables and harnesses with electrical tape or wire ties to prevent them from interfering with moving parts. Never attempt to disassemble or modify the product.
PAGE 3
Optional Accessories Mounting Options VOLUME SPXR2 SPXR2 Wired Marine Remote Control the SPXM1 from the swim deck or seating area. SOURCE VOLUME BAND       The SPXM1 can be mounted using the Mounting Bracket or Mounting Screws. When possible, it is recommended to use both the U Bracket AND Mounting Screws. The mounting hole is 3" diameter. A 3” hole saw is recommended. Mount on flat surface. Check for obstructions behind mounting location before cutting.
PAGE 4
Wiring & Connections Solder and heat shrink or waterproof butt connectors are recommened for all wire connections RCA, USB and Antenna connections should be secured with heat shrink The SPXM1uses EEPROM memory, so there is no (Yellow) wire connected to the battery The Red (ACC 12V+) wire should be connected to switched power, not directly to battery The Camera/Video Input can be triggered with the Purple/White wire or selected as a Source ACCESSORY CONTROL WIRING The SPXM1 has 4 switchable outputs/triggers
PAGE 5
Specifications General AUX Input Operating Voltage: Max Current: Display: 2.
PAGE 6
CAN ICES-3(B) This device complies with Part 15 of the FCC Rules and with RSS-247 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.