Use and Care Manual
2
4
Maintenance and cleaning
• Disconnect the plug from the socket before cleaning or when the product is not in use for
prolonged periods of me.
• Do not clean the product unl 60 minutes aer it is turned o.
• When cleaning, do not spray cleaners or water directly into the product.
• Apply the cleaner on a cloth and wipe the product.
• For cleaning of reector plate, please remove the grills. Clean the reector plate with a
rag with glass cleaner, please DO NOT TOUCH the lamp with ngers or the cloth.
• For cleaning of the grills, please remove the grills. Clean the grills with a cloth with glass
cleaner.
• Regular maintenance of the product is recommended, as this will prolong the product’s
service life and appearance (in coastal areas, the product should cleaned more
frequently, due to atmospheric salinity).
• Regularly check the cord for damages and ensure that the plug is clean.
• If the power cord, lamp or other electrical parts needs replacing, this must be done only
by a qualied professional.
Troubleshoong
Follow the troubleshoong steps listed below:
• Make sure the power cord is connected correctly.
• Check the cable for any ruptures.
• Make sure the On/ O switch has been pressed.
• Check whether the bulb has blown.
• If the product is turned o due to overheang caused by improper use (overheat
sensor), the product must be disconnected from the socket outlet and cool o.
Check the product for defects aer 30 minutes of cooling. If there are no visible
defects, try to reconnect the product again.
Please contact the place of purchase if this did not solve your problem.
Side view
USA