Fitness Tracker ID115Plus HR User Manual Thank you for purchasing our products. This manual addresses the safety guidelines, warranty, and operating instructions. Please review this manual thoroughly before operating your device.
Getting Started What’s in the box Fitness tracker (ID115Plus HR with bands) Quick start guide Note: This tracker is designed with a built-in USB plug. No charging cable is required for charging, and no charging cable or wall charger is included in the package. What’s in this Document This manual gets you started quickly with setting up your tracker.
Setting up Your Tracker Charging your tracker This fitness tracker does not need a charging cable, it has a built-in charger in its body and you can charge it directly with its main body. Please charge your tracker for at least 10 minutes to have it activated before initial use. Step 1: Gently remove the strap on both sides of the device. Step 2: Find the metal pins on the device. Step 3: Plug into the USB port, make sure the metal pins of the device are connected to the metal pins of the USB port.
Assembling / Disassembling your tracker Assembly Insert the bands in the direction of the arrow. Disassembly Gently pull the bands off the tracker body in the direction of the arrow.
Wearing Your Tracker All-day wear and exercise For all-day wear when you’re not exercising, wear the device on your wrist horizontally, a Finger’s width below your wrist bone and lying flat, the same way you would put on a watch. For optimized heart rate tracking, keep these tips in mind: 1. Experiment with wearing the tracker higher on your wrist during exercise. Because the blood flow in your arm increases the farther up you go, moving the tracker up a couple of inches can improve the heart rate signal.
Using Your Tracker App Installation Use the tracker with our customized VeryFitPro app. You can download VeryFitPro from App Store/Google Play or scan the QR codes below to download. Notes: The VeryFitPro app is only compatible with smartphones, not tablets or PCs. Smartphone operating system should be iOS 7.1 / Android 4.4 or higher; Bluetooth version should be 4.0 or higher. Smart Phone System Requirements iOS 7.1 or higher Android 4.4 or higher Bluetooth 4.
Pairing the Tracker with Your Phone 1) Please ensure your phone’s Bluetooth is enabled before beginning the pairing process. 2) Open the VeryFitPro app on your smartphone and go to the "Device" page, tap "Pair device", then your smartphone starts searching devices. 3) In the list of found devices that appear on your phone, tap "ID115Plus HR" to connect the tracker to your smartphone.
FAQs 1. Failure to find the tracker when pairing 1) Make sure your smartphone’s Bluetooth is enabled and your smartphone’s system meets the requirements of Android 4.4 or higher, iOS 7.1 or higher, and Bluetooth 4.0 or higher. 2) Make sure the distance between your smartphone and the tracker does not exceed 0.5 meters and that Bluetooth communication is also within range (10 meters max). 3) Make sure your tracker has enough battery life.
To test the accuracy of the pedometer, please walk casually and continuously at least 100 steps. 6. Failure to measure heart rate Make sure the tracker sits neatly on your wrist before use. Tap the touch key to enter heart rate mode and wait 10-20s to obtain your heart rate. 7. Failure to connect to smartphone The tracker will disconnect from your smartphone in the following cases: 1.
Important Safety Instructions The device contains electrical equipment that may cause injury if not used properly. For example, prolonged contact may contribute to skin allergies for some users. To reduce irritation, please read the safety guidelines on the following pages to ensure proper use and care. Do not expose your device to liquid, moisture, humidity or rain while charging; do not charge your device when it is wet, as this may result in electrical shock and injury. Keep your device clean and dry.