User's Manual
•
Press in the button
Compression pressure is released
when the button is pressed in.
This helps reduce the effort
required to pull the starter rope.
•
For this reason the botton should
be pressed in before each starting
attempt.
•
Observe safety precautions -
see section "Safety Precautions".
Push hand guard forward :
The chain is now locked -
Press throttle trigger interlock
and set
•
Master Control lever to:
For cold start N
For warm start Q
(even if engine has been running
but is still cold)
•
Place your saw on the ground -
make sure you have a firm footing -
check that chain is not touching any
objects or the ground -
bystanders must be well clear of
general work area of the saw -
•
Hold the saw firmly on the ground
with your left hand on the front
handle - your left thumb should be
under the handle -
•
put your right foot into the rear
handle and press down.
133BA001 K
2
1
0
STOP
143BA018 KN
6WDUWLQJWKH6DZ