Owner's Manual

SR 430, SR 450
English
14
N Slide the narrow hose clamp (6)
onto the pleated hose (4).
N Secure the hose clamp (6) with the
screw (8) from the side facing the
operator – make sure the antistatic
wire is positioned in the notch.
Adjusting and securing the control
handle
N Put the machine on your back and
adjust the harness – see "Harness".
N Slide the control handle (1) along
the tube to the most comfortable
position – distance between nozzle
outlet (2) and the control handle (1)
must be at least 19.7 in. (a)
(500 mm).
N Secure the control handle (1) with
the screw (3).
N Use the retainer (4) to secure the
hose and throttle cable, and
metering unit's operating cable on
the SR 450, to the 6th pleat (arrow)
on the pleated hose.
It may be necessary to correct the
adjustment of the throttle cable after
assembling the machine or after a
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
assembled.
N Set throttle trigger to the full throttle
position – as far as stop.
N Carefully rotate the screw in the
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another full turn.
6
8
4
6
8
0002BA010 KN
a
1
0002BA011 KN
2
0002BA058 KN
1
3
4
0002BA012 KN
Adjusting the Throttle
Cable
0002BA013 KN