Instruction Manual

SR 430, SR 450
English
17
Fitting the antistatic system – SR 450
only
N Attach the antistatic wire (1) and
chain (2) to the blower housing with
screw (3).
Fitting the pleated hose on the elbow –
SR 450 only
N Push the antistatic wire (1) into the
pleated hose (2).
N Push narrow hose clamp (3), marks
facing left, onto the elbow (4).
N Route the antistatic wire (1) through
the slot in the hose clamp (3).
N Push the pleated hose (2) onto the
elbow (4).
N Push the hose clamp (3) onto the
pleated hose (2).
N Line up the marks on the hose
clamp (3) and elbow (4) – as shown.
N Secure the hose clamp (3) with the
screw (5) – make sure the antistatic
wire is located in the notch.
Adjusting and securing the control
handle
N Put the machine on your back and
adjust the harness – see "Harness".
N Slide the control handle (1) along
the tube to the most comfortable
position – distance between nozzle
outlet (2) and the control handle (1)
must be at least 19.7 in (500 mm)
('a').
N Secure the control handle (1) with
the screw (3).
3
1
2
0002BA069 KN
1
0002BA078 KN
2
4
3
0002BA079 KN
2
1
3
3
5
2
5
0002BA080 KN
4
4
a
1
0002BA011 KN
2
0002BA058 KN
1
3