User Instructions

0478 131 9954 C - EN
184
– Check routing of the perimeter wire
(Ö 11.13), check clearances using the
iMOW® Ruler (Ö 12.5)
– Cut the unmown areas regularly using a
suitable grass trimmer
Fault:
No wire signal
Possible cause:
– Docking station switched off – no LED
illuminates
– Docking station not connected to mains
supply – no LED illuminates
– Perimeter wire not connected to the
docking station – red LED flashes
(Ö 13.1)
– Break in perimeter wire – red LED
flashes (Ö 13.1)
– Robotic mower and docking station are
not linked
– Electronics fault– LED flashes SOS
(Ö 13.1)
Remedy:
– Switch on the docking station (Ö 13.1)
– Check power supply to the docking
station (Ö 9.8)
– Connect the perimeter wire to the
docking station (Ö 9.10)
– Find the wire break (Ö 16.7), then
repair perimeter wire using wire
connectors (Ö 12.16)
– Link robotic mower and docking station
(Ö 11.15)
– Contact your specialist dealer (#)
Fault:
LED on the docking station flashes SOS
Possible cause:
– Minimum perimeter wire length not
reached
– Electronics fault
Remedy:
– Install the accessory (AKM 100) (#)
– Contact your specialist dealer (#)
Fault:
The robotic mower is not receiving any
GPS signal
Possible cause:
– The connection to the satellites is
currently being established
– 3 or fewer satellites within range
– The machine is in a dead spot
Remedy:
– No further action required; it can take a
few minutes for the connection to be
established
– Avoid or remove obstacles that might
be blocking the signal (e.g. trees,
canopies)
Fault:
The robotic mower cannot establish a
mobile radio connection
Possible cause:
– The mowing area is in a dead spot
– The radio module is not activated
Remedy:
– Have the radio module activated by a
STIHL specialist dealer (#)
Fault:
The robotic mower cannot be reached
using the app
Possible cause:
– Radio module inactive
– The robotic mower is in standby mode
– No Internet connection
– The robotic mower is not associated
with the correct e-mail address
Remedy:
– The radio module is switched off during
linking, then it is reactivated and the
robotic mower can be reached again
– Activate the robotic mower by pressing
the button, set "Standard" energy mode
(Ö 11.10)
– Connect the machine on which the app
is installed to the Internet
– Correct the e-mail address (Ö 10.)
26.1 Handover confirmation
26. Service schedule