User Instructions

Table Of Contents
177
DEFRNLIT EN
0478 131 9954 C - EN
Message:
1135 – Outside
Place the iMOW® on the mowing area
Possible cause:
The robotic mower is located outside
the mowing area
Remedy:
Return robotic mower to the mowing
area
Message:
1140 – Too steep
Check wire routing
Possible cause:
Tilt sensor has detected slope
inclination exceeding 22°
Remedy:
Change routing of perimeter wire, block
off lawns with slope inclinations
exceeding 22°
Message:
1160 – Handle actuated
Press OK to release
Possible cause:
The robotic mower has been lifted by
the carry handle
Remedy:
Confirm message with OK
Message:
1170 – No signal
Switch on docking station
Possible cause:
Docking station is switched off
No reception of wire signal during
operation
The robotic mower is located outside
the mowing area
Docking station or electronic
components were replaced
Remedy:
Switch on docking station and give
mowing command
Check power supply to the docking
station
Check LED on the docking station – the
red LED must be permanently
illuminated during operation (Ö 13.1)
Return robotic mower to the mowing
area
Link robotic mower and docking station
(Ö 11.15)
Message:
1180 – Dock iMOW®
Automatic docking
not possible
Possible cause:
The docking station was not found
The start or end of a corridor was
installed incorrectly
Remedy:
Check LED on the docking station,
switch on the docking station if
necessary (Ö 13.1)
Check docking (Ö 15.7)
Check funnel-shaped entrance and exit
areas of the corridor (Ö 12.11)
Message:
1190 – Docking error
Docking station occupied
Possible cause:
Docking station occupied by a second
robotic mower
Remedy:
Dock the robotic mower once the
docking station is unoccupied again
Message:
1200 – Mowing motor fault
Mowing motor start not possible after 5
attempts
Possible cause:
Dirt between carrier plate and mowing
deck housing
Mowing motor cannot be switched on
Mowing motor overloaded
Remedy:
Clean mowing blade and mowing deck
(Ö 16.2)
Clean carrier plate (Ö 16.6)
Set higher cutting height (Ö 9.5)
Level out any uneven areas (holes,
depressions) in the mowing area
Message:
1210 – Drive motor fault
Wheel stuck
Possible cause:
Overload at a drive wheel
Remedy:
Clean the robotic mower (Ö 16.2)
Level out any uneven areas (holes,
depressions) in the mowing area
Message:
1220 – Rain detected
Mowing interrupted
Possible cause:
Mowing operation has been interrupted
or not started due to rain
Remedy:
No action necessary; adjust rain sensor
if required (Ö 11.11)