User Instructions

167
DEFRNLIT EN
0478 131 9954 C - EN
Searching with the control panel
removed:
Starting at the docking station, follow the
edge of the mowing area clockwise with
the robotic mower (1). Steer the machine
using the control pad for this purpose and
ensure that the perimeter wire (2) runs
under the wire sensor. The wire sensors
are installed in a protected position on the
left and right at the front of the robotic
mower.
During the wire break search, the signal
strength is indicated on the display; the
wire sensors are in the ideal position
above the perimeter wire when this value
is at its highest.
The Wire signal OK symbol
appears on the display when
the wire sensors are correctly
receiving the wire signal.
In the area of the wire break, the
signal strength drops and the
Check wire signal symbol
appears on the display.
● Bridge the break with the aid of a wire
connector (Ö 12.16). If necessary, re-
route the perimeter wire in the area of
the break.
● Reconnect the left wire end. (Ö 9.10)
● Once the wire break has been correctly
rectified, the red LED illuminates.
(Ö 13.1)
Fine search with the control panel
inserted:
Lift the robotic mower slightly by the
carrying handle (1) and relieve the weight
on the drive wheels. Push the machine,
resting on its front wheels, and follow the
perimeter wire (2).
The further procedure corresponds to the
search with the control panel removed.
16.8 Storage and winter break
Note the following points when storing the
robotic mower (e.g. winter break,
temporary storage):
● Charge the battery (Ö 15.8)
● Switch off automatic mowing (Ö 11.7)
● Activate the highest safety level
(Ö 11.15)
● RMI 632 C, RMI 632 PC:
Activate ECO energy mode (Ö 11.10)
● Place the robotic mower in hibernation
(Ö 11.16)
● Disconnect the power supply unit plug
from the mains
● Carefully clean all external parts of the
robotic mower and the docking station.
Cover the docking station with a suitable
bucket, fasten the bucket.
● Store the robotic mower on its wheels in
a dry, closed and dust-free room. Make
sure that the machine is kept out of the
reach of children.
● Always store the robotic mower in good
operational condition.
● Keep all screws tightly fastened,
replace danger signs and warnings on
the machine that have become illegible,
check the entire machine for wear and
damage. Replace all worn or damaged
parts.
● Any machine faults must be completely
remedied prior to storage.