User Instructions

Table Of Contents
0478 131 9942 C - EN
166
Message:
1000 – Rollover
Allowed inclination exceeded
Possible cause:
Tilt sensor has detected a rollover
Remedy:
Place the robotic mower on its wheels,
check for damage and confirm the
message with OK
Message:
1010 – iMow raised
Press OK to release
Possible cause:
Robotic mower has been lifted by the
hood
Remedy:
Check movement of the hood and
confirm the message with OK
Message:
1030 – Hood fault
Check hood
Then press OK
Possible cause:
No hood detected
Remedy:
Check hood (movement, firm seating)
and confirm the message with OK
Message:
1100 – Control panel
Control panel removed during travelling
Possible cause:
Control panel has been removed during
automatic operation
Remedy:
Confirm the message with OK –
automatic operation resumes once the
control panel has been inserted
Message:
1120 – Hood blocked
Check hood
Then press OK
Possible cause:
Permanent collision detected
Remedy:
Free the robotic mower, remove the
obstacle or change routing of perimeter
wire if necessary – then confirm the
message with OK
Check movement of the hood and
confirm the message with OK
Message:
1125 – Remove obstacle
Check wire routing
Possible cause:
Perimeter wire routed inaccurately
Remedy:
Check the routing of the perimeter wire;
check the clearances with the
iMow Ruler (Ö 12.5)
Message:
1130 – Stuck
Free iMow
Then press OK
Possible cause:
Robotic mower has become stuck
Drive wheels are spinning
Remedy:
Free the robotic mower, level out the
mowing area or change routing of
perimeter wire if necessary – then
confirm the message with OK
Clean the drive wheels, if necessary
prevent operation during rain – then
confirm the message with OK (Ö 11.12)
Message:
1131 – Stuck
On level surfaces:
Deactivate ASM
Possible cause:
ASM also activated on a level surface
Remedy:
Deactivate ASM on level surfaces
(Ö 11.14)
Message:
1135 – Outside
Place iMow in mowing area
Possible cause:
The robotic mower is located outside
the mowing area
Remedy:
Return the robotic mower to the mowing
area