User Instructions

0478 131 9942 C - EN
138
3. GPS protection
(RMI 632 C, RMI 632 PC):
For switching position monitoring on
and off. (Ö 5.10)
4. Change PIN code:
The 4-digit PIN code can be
changed if required.
● First enter the old PIN code and confirm
with OK.
● Then enter the new 4-digit PIN code
and confirm with OK.
5. Start signal:
For switching on and off the acoustic
signal that sounds when the mowing
blade is activated.
6. Alarm signal:
For switching on and off the acoustic
signal that sounds when the robotic
mower hits an obstacle.
7. Menu signal:
For switching on and off the acoustic
click that sounds when a menu is
opened and a selection is confirmed with
OK.
8. Child lock:
If the impact sensor is triggered several
times in succession within a short time, the
robotic mower and the mowing blade will
stop.
If the impact sensor is not triggered again,
the robotic mower will continue automatic
mowing after a few seconds.
9. Keylock:
When the keylock is switched on,
the buttons on the control panel
can only be operated if the Back
button is pressed and held and the
control pad is then pressed forwards.
The keylock is activated 2 minutes after
the last button has been pressed.
10. Link iMow and dock:
Following initial operation, the
robotic mower can only be operated
in conjunction with the docking station
supplied.
Following a replacement of the docking
station or of electronic components in the
robotic mower or for operation of the
robotic mower on an additional mowing
area using a different docking station, the
robotic mower and docking station must be
linked.
● Install the docking station and connect
the perimeter wire. (Ö 9.9), (Ö 9.11)
Lift the robotic mower slightly by the
carrying handle (1) and relieve the weight
on the drive wheels. Push the machine,
resting on its front wheels, into the docking
station.
● After pressing the OK button,
enter the PIN code. The robotic
mower will then search for the
wire signal and save it automatically.
This process takes several minutes.
(Ö 9.12)
11.17 Service
1. Blade change:
Installation of a new mowing blade is
confirmed with OK.
2. Find wire break:
If the red LED on the docking station
flashes rapidly, there is a break in the
perimeter wire. (Ö 13.1)
Recommendation:
Always switch on GPS protection.
Before switching on, enter the
mobile phone number of the
owner in the app (Ö 10.) and set
the safety level "Low", "Medium" or
"High" on the robotic mower.
The "Change PIN code" menu item
is only displayed in the safety levels
"Low", "Medium" or "High".
Recommendation:
Write down the new PIN code.
If the PIN code is entered
incorrectly 5 times, a 4-digit master
code is required, otherwise
automatic operation is switched off.
For the creation of a master code,
you must provide your specialist
dealer with the 9-digit serial number
and the 4-digit date, which are
displayed in the selection window.
No PIN code is required in the
safety level "None".
If the blade has been in use for
more than 200 hours, the message
"Replace mowing blade" appears.
(Ö 16.4)