Instruction Manual

0478 131 9265 B - EN
80
Message:
2000 – Signal problem
Dock iMOW®
Possible cause:
– Wire signal faulty, fine tuning necessary
Remedy:
– Place robotic mower in docking station
– then press OK
Message:
2020 – Recommendation
Annual service by spec. dealer required
Possible cause:
– Machine service recommended
Remedy:
– Have the annual service carried out by
a STIHL specialist dealer
Message:
2030 – Battery
Allowed operating time reached
Possible cause:
– Battery replacement necessary
Remedy:
– Have the battery replaced by a STIHL
specialist dealer
Message:
2031 – Charging failure
Check charging contacts
Possible cause:
– Charging cannot be started
Remedy:
– Check docking station and robotic
mower charging contacts and clean if
necessary – then confirm message with
OK
Message:
2032 – Battery temperature
Outside temperature range
Possible cause:
– Temperature in battery during charging
too low or too high
Remedy:
– Allow robotic mower to warm up or cool
it down – observe permissible
temperature range of battery
Message:
2040 – Battery temperature
Outside temperature range
Possible cause:
– Temperature in battery when starting
mowing operation too low or too high
Remedy:
– Allow robotic mower to warm up or cool
it down – observe permissible
temperature range of battery (Ö 6.4)
Message:
2050 – Adapt mowing plan
Extend active times
Possible cause:
– Active times have been
shortened/deleted or the mowing
duration has been extended – the
stored active times are insufficient for
the necessary mowing operations.
Remedy:
– Extend the active times (Ö 11.7) or
shorten the mowing duration (Ö 11.7)
Message:
2060 – Mowing completed
Press OK to release
Possible cause:
– Mowing in secondary area successfully
completed
Remedy:
– Return robotic mower to mowing area
and dock to charge battery (Ö 15.6)
Message:
2070 – GPS signal
No reception at edge
Possible cause:
– The entire edge of the mowing area is in
a dead spot
Remedy:
– Repeat edge following (Ö 11.13)
– Contact a STIHL specialist dealer for a
detailed diagnosis
Message:
2071 – GPS signal
No reception at starting pt. 1
Possible cause:
– Starting point 1 is in a dead spot
Remedy:
– Change the position of starting point 1
(Ö 11.14)
Message:
2072 – GPS signal
No reception at starting pt. 2
Possible cause:
– Starting point 2 is in a dead spot
Remedy:
– Change the position of starting point 2
(Ö 11.14)