Instruction Manual

Table Of Contents
ENES
77
PTSLSKCS
0478 131 9265 B - EN
Message:
0183 – Temperature high
Charge control circuit board
Possible cause:
Temperature inside robotic mower too
high
Remedy:
Allow robotic mower to cool down
Message:
0185 – Temperature high
Drive control circuit board
Possible cause:
Temperature inside robotic mower too
high
Remedy:
Allow robotic mower to cool down
Message:
0186 – Temperature low
Battery
Possible cause:
Battery temperature too low
Remedy:
Allow robotic mower to warm up
Message:
0187 – Temperature high
Battery
Possible cause:
Battery temperature too high
Remedy:
Allow robotic mower to cool down
Message:
0302 – Drive motor fault
Temperature range exceeded
Possible cause:
Temperature in left drive motor too high
Remedy:
Allow robotic mower to cool down
Message:
0305 – Drive motor fault
Left wheel is stuck
Possible cause:
Overload at left drive wheel
Remedy:
Clean robotic mower (Ö 16.2)
Level out any uneven areas (holes,
depressions) in mowing area
Message:
0402 – Drive motor fault
Temperature range exceeded
Possible cause:
Temperature in right drive motor too
high
Remedy:
Allow robotic mower to cool down
Message:
0405 – Drive motor fault
Right wheel is stuck
Possible cause:
Overload at right drive wheel
Remedy:
Clean robotic mower (Ö 16.2)
Level out any uneven areas (holes,
depressions) in mowing area
Message:
0502 – Mowing motor fault
Temperature range exceeded
Possible cause:
Temperature in mowing motor too high
Remedy:
Allow robotic mower to cool down
Message:
0505 – Mowing motor fault
Mowing motor overloaded
Possible cause:
Dirt between carrier plate and mowing
deck housing
Mowing motor cannot be switched on
Mowing motor overloaded
Remedy:
Clean mowing blade and mowing deck
(Ö 16.2)
Clean carrier plate (Ö 16.6)
Set higher cutting height (Ö 9.5)
Level out any uneven areas (holes,
depressions) in the mowing area
Message:
0701 – Battery temperature
Outside temperature range
Possible cause:
Temperature in battery too low or too
high
Remedy:
Allow robotic mower to warm up or cool
it down – observe permissible
temperature range of battery (Ö 6.4)