User Instructions

171
DEFRNLIT EN
0478 131 9957 B - EN
Message:
0302 – Drive motor fault
Temperature range exceeded
Possible cause:
– Temperature in left drive motor too high
Remedy:
– Allow the robotic mower to cool down
Message:
0305 – Drive motor fault
Left wheel is stuck
Possible cause:
– Overload at left drive wheel
Remedy:
– Clean the robotic mower (Ö 16.2)
– Level out any uneven areas (holes,
depressions) in the mowing area
Message:
0402 – Drive motor fault
Temperature range exceeded
Possible cause:
– Temperature in right drive motor too
high
Remedy:
– Allow the robotic mower to cool down
Message:
0405 – Drive motor fault
Right wheel is stuck
Possible cause:
– Overload at right drive wheel
Remedy:
– Clean the robotic mower (Ö 16.2)
– Level out any uneven areas (holes,
depressions) in the mowing area
Message:
0502 – Mowing motor fault
Temperature range exceeded
Possible cause:
– Temperature in mowing motor too high
Remedy:
– Allow the robotic mower to cool down
Message:
0505 – Mowing motor fault
Mowing motor overloaded
Possible cause:
– Dirt between carrier plate and mowing
deck housing
– Mowing motor cannot be switched on
– Mowing motor overloaded
Remedy:
– Clean mowing blade and mowing deck
(Ö 16.2)
Clean carrier plate (Ö 16.6)
– Set higher cutting height (Ö 9.5)
– Level out any uneven areas (holes,
depressions) in the mowing area
Message:
0701 – Battery temperature
Outside temperature range
Possible cause:
– Temperature in battery too low or too
high
Remedy:
– Allow the robotic mower to warm up or
cool down – observe permissible
temperature range of battery (Ö 6.4)
Message:
0703 – Battery discharged
Battery voltage too low
Possible cause:
– Battery voltage too low
Remedy:
– Place robotic mower in the docking
station to recharge the battery (Ö 15.7)
Message:
0704 – Battery discharged
Battery voltage too low
Possible cause:
– Battery voltage too low
Remedy:
– Place robotic mower in the docking
station to recharge the battery (Ö 15.7)
Message:
1000 – Rollover
Allowed inclination exceeded
Possible cause:
– Tilt sensor has detected a rollover
Remedy:
– Place the robotic mower on its wheels,
check for damage and confirm the
message with OK
Message:
1010 – iMOW® raised
Press OK to release
Possible cause:
– Robotic mower has been lifted by the
hood
Remedy:
– Check movement of the hood and
confirm message with OK