User Instructions

0478 131 9944 C - EN
170
– Find the wire break (Ö 16.7), then
repair the perimeter wire using wire
connectors (Ö 12.16)
– Link the robotic mower and docking
station (Ö 11.16)
– Contact your specialist dealer (#)
Fault:
LED on the docking station flashes SOS
Possible cause:
– Minimum perimeter wire length not
reached
– Electronics fault
Remedy:
– Install the accessory (AKM 100) (#)
– Contact your specialist dealer (#)
Fault:
The robotic mower is not receiving any
GPS signal
Possible cause:
– The connection to the satellites is
currently being established
– 3 or fewer satellites within range
– The machine is in a dead spot
Remedy:
– No further action required; it can take a
few minutes for the connection to be
established
– Avoid or remove obstacles that might
be blocking the signal (e.g. trees,
canopies)
Fault:
The robotic mower cannot establish a
mobile radio connection
Possible cause:
– The mowing area is in a dead spot
– The radio module is not activated
Remedy:
– Have the radio module checked by a
STIHL specialist dealer (#)
Fault:
The robotic mower cannot be reached
using the app
Possible cause:
– Radio module inactive
– The robotic mower is in standby mode
– No Internet connection
– The robotic mower is not associated
with the correct e-mail address
Remedy:
– The radio module is switched off during
linking, then it is reactivated and the
robotic mower can be reached again
– Activate the robotic mower by pressing
the button, set "Standard" energy mode
(Ö 11.11)
– Connect the machine on which the app
is installed to the Internet
– Correct the e-mail address (Ö 10.)
26.1 Handover confirmation
26.2 Service confirmation
Please hand this instruction manual
to your STIHL specialist dealer in
the case of maintenance operations.
He will confirm the service operations
performed in the pre-printed boxes.
26. Service schedule
Service performed on
Next service date
2