User Instructions

0478 131 9944 C - EN
166
Message:
2100 – GPS protect.
Outside home area
Machine disabled
Possible cause:
– The robotic mower was removed from
the home area
Remedy:
– Return the robotic mower to the home
area and enter the PIN code (Ö 5.9)
Message:
2110 – GPS protect.
New location
New installation req.
Possible cause:
– The robotic mower was operated on a
different mowing area. The wire signal
of a second docking station is already
stored.
Remedy:
– Perform new installation (Ö 11.14)
Message:
2120 – Child lock
Child lock active
Possible cause:
– Impact sensor triggered several times
consecutively
– Robotic mower has been lifted during
travel
Remedy:
– No action required – if the impact
sensor is not triggered again, the
message automatically becomes
inactive within max. 1 minute
– Deactivate the child lock (Ö 11.16)
Message:
2400 – iMow successfully reset to factory
default
Possible cause:
– Robotic mower has been reset to
factory default
Remedy:
– Confirm message with OK
Message:
4001 – Internal fault
Outside temperature range
Possible cause:
– Temperature in battery or inside the
machine too low or too high
Remedy:
– Allow the robotic mower to warm up or
cool down – observe permissible
temperature range of battery (Ö 6.4)
Message:
4002 – Rollover
see message 1000
Message:
4003 – Hood lifted
Check hood
Then press OK
Possible cause:
– Hood has been lifted
Remedy:
– Check the hood and confirm the
message with OK
Message:
4004 – Internal fault
Press OK to release
Possible cause:
– Error in the programme sequence
– Power failure during automatic
operation
– Robotic mower is located outside the
mowing area
Remedy:
– Confirm message with OK
– Check power supply to the docking
station – the red LED must be
illuminated permanently during
operation; then press the OK
button (Ö 13.1)
– Return the robotic mower to the mowing
area, then press the OK button
Message:
4005 – Internal fault
see message 4004
Message:
4006 – Internal fault
see message 4004
Message:
4027 – STOP button pressed
Press OK to release
Possible cause:
– STOP button has been pressed
Remedy:
– Confirm message with OK