User Instructions

0478 131 9944 C - EN
162
Message:
0505 – Mowing motor fault
Mowing blade blocked
Possible cause:
– Dirt between carrier plate and mowing
deck housing
– Mowing motor cannot be switched on
– Mowing motor overloaded
Remedy:
– Clean mowing blade and mowing deck
(Ö 16.2)
Clean carrier plate (Ö 16.6)
– Set higher cutting height (Ö 9.5)
– Level out any uneven areas (holes,
depressions) in the mowing area
Message:
0703 – Battery discharged
see message 0100
Message:
0704 – Battery discharged
see message 0100
Message:
1000 – Rollover
Allowed inclination exceeded
Possible cause:
– Tilt sensor has detected a rollover
Remedy:
– Place the robotic mower on its wheels,
check for damage and confirm the
message with OK
Message:
1010 – iMow raised
Press OK to release
Possible cause:
– Robotic mower has been lifted by the
hood
Remedy:
– Check movement of the hood and
confirm the message with OK
Message:
1030 – Hood fault
Check hood
Then press OK
Possible cause:
– No hood detected
Remedy:
– Check hood (movement, firm seating)
and confirm the message with OK
Message:
1105 – Flap open
Operation aborted
Possible cause:
– Flap open during automatic operation
– Flap open during automatic edge
following
Remedy:
– Close the flap (Ö 15.2)
Message:
1120 – Hood blocked
Check hood
Then press OK
Possible cause:
– Permanent collision detected
Remedy:
– Free the robotic mower, remove the
obstacle or change routing of perimeter
wire if necessary – then confirm the
message with OK
– Check movement of the hood and
confirm the message with OK
Message:
1125 – Remove obstacle
Check wire routing
Possible cause:
– Perimeter wire routed inaccurately
Remedy:
– Check the routing of the perimeter wire;
check the clearances with the
iMow Ruler (Ö 12.5)
Message:
1130 – Stuck
Free iMow
Then press OK
Possible cause:
– Robotic mower has become stuck
– Drive wheels are spinning
Remedy:
– Free the robotic mower, level out the
mowing area or change routing of
perimeter wire if necessary – then
confirm the message with OK
– Clean the drive wheels, if necessary
prevent operation during rain – then
confirm the message with OK (Ö 11.12)