User Instructions

147
DEFRNLIT EN
0478 131 9944 C - EN
14.5 Home area (RMI 422 PC)
The robotic mower identifies its location
using the built-in GPS receiver. During
each edge following run to check the
correct wire routing (Ö 9.12) and when
entering in the starting points (Ö 11.15),
the robotic mower stores the coordinates
of the most westerly, easterly, southerly
and northerly point.
This area is defined as the home area and
the robotic mower can be used here. The
coordinates are updated each time edge
following is repeated.
When GPS protection is activated, the
owner of the machine is notified if the
machine is operated outside the home
area. The PIN code is also requested on
the robotic mower display.
15.1 Preparation
● Install the docking station (Ö 9.8)
● Route (Ö 9.9) and connect (Ö 9.10) the
perimeter wire
● Remove foreign bodies (e.g. toys,
tools) from the mowing area
● Charge the battery (Ö 15.7)
● Set the time and date (Ö 11.11)
● Check the mowing plan and adapt if
necessary – in particular it must be
ensured that third parties keep away
from the danger area during active
times. (Ö 11.6)
15.2 Flap
The robotic mower is equipped with a flap
which protects the display from the
weather and from inadvertent operation. If
the flap is opened during use of the robotic
mower, operation is stopped and the
mowing blade and robotic mower come to
a standstill.
Opening the flap:
Grasp the flap (1) at the lifting point (A)
and release upwards by pulling lightly.
Open the flap as far as it will go.
Closing the flap:
Carefully fold the flap downwards and
allow to engage.
15.3 Adapting the programming
The current programming can be seen in
the Mowing plan or, in the case of model
RMI 422 PC, in the iMow app. (Ö 11.6)
The mowing plan is calculated based on
the size of the mowing area during
installation or during the creation of a new
mowing plan.
The active times and the mowing
duration can be changed individually, the
required mowing operations themselves
are automatically distributed over the
possible active times. If required, several
mowing or charging operations can run
during an active time. If required, the edge
of the mowing area can be cut
automatically at regular intervals.
(Ö 11.14)
Up to three different active times per day
are possible. (Ö 11.7)
If the robotic mower has to travel to
specific areas of the mowing area, starting
points must be defined. (Ö 11.15)
15. Operating the machine
An installation assistant is available
for initial installation. (Ö 9.)
The robotic mower should be
charged and operated at an
ambient temperature between +5°C
and +40°C.
Mow very high grass until it is short
using a conventional lawn mower
prior to use of the robotic mower
(e.g. following a lengthy break).
For safety reasons, the Stop button
must be pressed before opening
the flap during operation of the
robotic mower.
The opened flap can be removed
upwards from the machine. This
design is implemented for safety
reasons: this ensures that the
machine cannot be lifted and
carried by the flap.
The robotic mower can only be
operated when the flap is fully
engaged.