Operation Manual

RMA 510
English
17
N Line up the handle knobs (1) in one
of the three positions on the
brackets (3).
N Rotate the handle knobs (1) 90° so
that they engage the holes in the
brackets (3).
Make sure that both handle knobs (1)
are in the same position.
Unfolding the upper handle
N Unfold the upper handle (4).
N Tighten down the star knobs (5)
clockwise.
Different cutting heights can be
selected.
Adjusting Cutting Height
To incerase cutting height:
N Pull cutting height adjustment
lever (1) toward rear of mower.
Reduce cutting height:
N Pull cutting height adjustment
lever (1) toward front of mower.
The selected cutting height is shown.
Power supply (mains) voltage and
operating voltage must be the same.
N Insert the plug (1) in the wall
outlet (2).
A self test is performed after the charger
is connected to the power supply. During
this process, the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.
90°
0000-GXX-2639-A0
3
1
0000-GXX-2644-A0
4
5
Adjusting Cutting Height
Setting Cutting
height
1 35mm (1.4in)
2 43mm (1.7in)
3 52mm (2in)
4 60mm (2.4in)
5 71mm (2.8in)
6 79mm (3in)
7 90mm (3.5in)
0000-GXX-2646-A0
1
Connecting Charger to
Power Supply
3901BA015 KN
2
1
1
3901BA019 KN