Instruction Manual

RMA 510
English
25
Troubleshooting
Always remove the activation key and battery before carrying out any work on the machine.
Condition Cause Remedy
Machine does not start when switched on
No electrical contact between machine
and battery
Remove the battery, visually check con-
tacts and refit battery
Battery is low on charge
(1 LED on battery flashes green)
Charge the battery
Battery too hot / too cold
(1 LED on battery glows red)
Allow battery to cool down / allow battery
to warm up slowly at temperatures of
about 15°C - 20°C (60°F - 70°F)
Malfunction in battery
(4 LEDs on battery flash red)
Take the battery out of the machine tool
and refit it. Switch on the machine – if the
LEDs continue to flash, the battery has a
malfunction and must be replaced.
Fuse key not fitted Inserting the Activation Key
Malfunction in activation key Replace activation key
Machine too hot
(3 LEDs on battery glow red)
Allow machine to cool down
Electromagnetic problem or malfunction
in machine
(3 LEDs on battery flash red)
Take the battery out of the machine tool
and refit it. Switch on the machine – if the
LEDs still flash, the machine has a mal-
function and must be checked by a
servicing dealer
1)
Motor overloaded by overlong or damp
grass.
Do not start the motor in overlong grass,
adjust cutting height to suit conditions
Mower deck blocked Clean mower deck
Moisture in machine and/or battery Allow machine / battery to dry
Machine cuts out during operation
Battery or machine's electronics too hot Take battery out of machine, allow bat-
tery and machine to cool down
Electrical or electromagnetic malfunction Remove the battery and refit it
Mowing overlong grass or at too low a
cutting height
Allow machine to cool down, adjust cut-
ting height to suit conditions
Feed speed too high Allow machine to cool down, reduce
speed
Cooling inlets dirty Allow machine to cool down, clean cool-
ing air openings in motor housing