Instruction Manual

RMA 510
English
15
During Operation
N Press button (1) to activate the
display – the display goes off
automatically after 5 seconds.
The green LEDs glow continuously or
flash to indicate the state of charge.
If the LEDs on the battery flash or glow
red – see "If the red LEDs glow
continuously / flash".
If the red LEDs glow continuously / flash
1
3901BA010 KN
3901BA016 KN
80 - 100 %
60 - 80 %
40 - 60 %
20 - 40 %
0 - 20 %
A 1 LED glows
continuously
red:
Battery is too hot
1) 2)
/cold
1)
1)
When charging: Charge process
starts automatically after the battery
has cooled down / warmed up.
2)
During operation: Machine cuts out
– allow battery to cool down; it may
be necessary to take the battery out
of the machine for this purpose.
B 4 LEDs flash
red
Malfunction in
battery
3)
C 3 LEDs glow
continuously
red:
Machine is too hot
– allow it to cool
down.
D 3 LEDs flash
red
Malfunction in
machine
4)
3901BA041 KN
A
B
C
D
3)
Electromagnetic problem or fault.
Take the battery out of the machine
tool and refit it. Switch on the
machine – if the LEDs continue to
flash, the battery is faulty and must
be replaced.
4)
Electromagnetic problem or fault.
Take the battery out of the
machine. Use a blunt tool to
remove dirt from the contacts in the
battery compartment. Refit the
battery. Switch on the machine – if
the light emitting diodes still flash,
the machine is faulty and must be
checked by a servicing dealer –
STIHL recommends an authorized
STIHL servicing dealer.