Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Overview
- 4 Safety Precautions
- 5 Preparing the Lawn Mower for Operation
- 6 Charging the Battery, LEDs
- 7 Assembling the Lawn Mower
- 8 Adjusting Lawn Mower for the User
- 9 Inserting and Removing Activation Key
- 10 Removing and Fitting the Battery
- 11 Switching the Lawn Mower On and Off
- 12 Checking the Lawn Mower and Battery
- 13 Operating the Lawn Mower
- 14 After Finishing Work
- 15 Transporting
- 16 Storing
- 17 Cleaning
- 18 Maintenance
- 19 Repairing
- 20 Troubleshooting
- 21 Specifications
- 22 Spare Parts and Accessories
- 23 Disposal
- 1 Prefácio
- 2 Informações sobre este manual de instruções
- 3 Visão geral
- 4 Indicações de segurança
- 5 Preparar o cortador de grama
- 6 Carregar bateria e LEDs
- 7 Montar o cortador de grama
- 8 Ajustar o cortador de grama para o usuário
- 9 Conectar e desconectar a chave de ativação
- 10 Inserir e tirar a bateria
- 11 Ligar e desligar o cortador de grama
- 12 Verificar o cortador de grama e a bateria
- 13 Trabalhar com o cortador de grama
- 14 Após o trabalho
- 15 Transporte
- 16 Armazenagem
- 17 Limpeza
- 18 Manutenção
- 19 Consertos
- 20 Solucionar distúrbios
- 21 Dados técnicos
- 22 Peças de reposição e acessórios
- 23 Descarte
0458-796-9921-A
25
English
20 Troubleshooting
Mower blade resistance is
too high.
► Increase cutting height:
► Switch on mower in low grass.
Mower cuts out
during operation.
3 LEDs glow red Mower is too hot. ► Remove the activation key.
► Remove the battery.
► Allow mower to cool down
► Clean the mower
► Do not switch the mower on and off too often in
quick succession.
► Walk forwards at a slower rate.
► Increase cutting height:
► Mow lower grass.
The blade is blocked. ► Remove the activation key.
► Remove the battery.
► Clean the mower
There is a electrical
malfunction.
► Remove battery and insert it again.
► Switch on the mower.
Mower runtime is too
short
Battery not fully charged. ► Fully charge the battery.
Normal battery life has
been exceeded.
► Replace the battery.
Charge process does
not start when
battery is inserted in
the charger.
1 LED glows red. Battery too hot or too cold. ► Leave battery in the charger.
Charge process starts automatically as soon as
permissible temperature range is reached.
Condition LEDs on Battery Cause Remedy