Instruction Manual

► Press sleeve (1) into the bores in upper han‐
dlebar (2).
► Fit spring washers (3) with the convex side
facing inwards onto sleeve (1).
► Guide upper handlebar (2) into handlebar
bracket (4).
► Push bolt (5) through the bores in handlebar
bracket (4) and the sleeve in upper handle‐
bar (2).
► Place nut (6) in the notch in handlebar
bracket (4).
► Tighten bolt (5).
► Press cable (7) into holders (8).
► Fasten cable (7) to the handlebar using cable
clip (9).
The handlebar must not be dismantled again.
7.2 Assembling, Attaching and
Detaching the Grass Catcher
Box
7.2.1 Assembling the Grass Catcher Box
► Fit upper part of grass catcher box (1) onto
lower part of grass catcher box (2).
► Press pins (3) through openings (4) from the
inside.
► Press upper part of grass catcher box (1)
downwards.
The upper part of the grass catcher box
engages with a click.
7.2.2 Attaching the Grass Catcher Box
► Switch the lawn mower off.
► Place the lawn mower on a level surface.
► Open discharge flap (1) and hold it open.
► Take hold of grass catcher box (2) by han‐
dle (3) and attach to mounts (5) using
hooks (4).
► Set down discharge flap (1) on grass catcher
box (2).
7.2.3 Detaching the Grass Catcher Box
► Switch the lawn mower off.
► Place the lawn mower on a level surface.
► Open the discharge flap and hold it open.
► Remove the grass catcher box upwards by the
handle.
► Close the discharge flap.
English 7 Assembling the Lawn Mower
34 0478-131-9948-C