Operation Manual

RMA 410 C
English
20
The LED (1) on the charger may glow
continuously green or flash red.
Green continuous light ...
... indicates the following:
The battery
– is being charged
– is too hot and must cool down
before charging
See also "LEDs on battery".
The green LED on the charger goes off
as soon as the battery is fully charged.
Red flashing light ...
... may indicate the following:
– No electrical contact between
battery and charger – remove and
refit the battery
– Malfunction in battery – see also
"LEDs on Battery".
– Malfunction in charger – have
checked by a servicing dealer.
STIHL recommends an authorized
STIHL servicing dealer.
A factory-new battery is not fully
charged.
It is advisable to charge the battery
completely before using it for the first
time.
Fitting the Battery
Open the battery compartment
N Press in the tab (1) and swing the
cover (2) to the rear.
Fit the fuse key
The motor can be started only when the
fuse key is fitted.
N Push the fuse key (3) into the
socket (4) as far as stop.
3)
Electromagnetic interference or
fault. Take the battery out of the
power tool and refit it. Switch on the
machine – if the LEDs continue to
flash, the battery has a malfunction
and must be replaced.
4)
Electromagnetic interference or
fault. Take the battery out of the
machine. Use a blunt tool to
remove dirt from the contacts in the
battery compartment. Refit the
battery. Switch on the power tool –
if the LEDs still flash, the power tool
has a malfunction and must be
checked by a servicing dealer –
STIHL recommends an authorized
STIHL servicing dealer.
LED on Charger
1
3901BA019 KN
Switching On
2
1
0000-GXX-0055-A0 KN
0000-GXX-0056-A0 KN
4
3