Operation Manual

RMA 410 C
English
17
Adjusting Cutting Height
N Hold the upper carrying grip (1) and
pull lever (2) upwards and keep it in
that position.
Increase cutting height:
N Use the upper carrying grip (1) to
raise the mower.
Reduce cutting height:
N Use the upper carrying grip (1) to
push mower down.
The chosen height setting is indicated
on the scale (3) by the pointer (4).
Power supply (mains) voltage and
operating voltage must be the same.
N Insert the plug (1) in the wall
outlet (2).
A self test is performed after the charger
is connected to the power supply. During
this process, the light emitting diode (1)
on the charger lights up green for about
1 second, then red and goes off again.
When delivered, the battery is not fully
charged.
It is advisable to charge the battery
completely before using it for the first
time.
N Connect the charger to the power
supply – mains voltage and
operating voltage of the charger
must be the same – see
"Connecting Charger to Power
Supply".
Operate the charger only in a closed, dry
space at ambient temperatures between
41 °F (5 ° C) and 104 °F (40 °C).
Only charge dry batteries. Allow a damp
battery to dry before charging.
N Slide the battery (1) into the
charger (2) until you start to feel
resistance – then push it in until it
engages.
1
3
2
0000-GXX-0053-A1 KN
Connecting Charger to
Power Supply
3901BA015 KN
2
1
1
3901BA019 KN
Charging the Battery
2
3901BA009 KN