Instruction Manual

0458-814-8621-A
28
English 13 After Finishing Work
► Wind up the high-pressure hose (1) and stow it on the
bracket (2).
► Roll up the power supply cord (3) and hang it onto the
brackets (4).
► Secure the power supply cord with the clip (5).
► Insert the detergent spray set (6).
► Insert the nozzle (7).
► Place the spray attachment in one of the holders (8).
13.2 Protecting the Pressure Washer in Winter
Conditions
Removing Water from the System
To remove any remaining water from the system:
► Switch off the pressure washer, @ 11.2.
► Disconnect the pressure washer from the power supply.
► Shut off the water supply.
► Relieve system pressure.
► Remove the high-pressure hose, @ 8.2.2.
► Disconnect the water hose, @ 9.
► Drain the water out of the high-pressure hose and water
hose.
► Connect the power supply cord to a properly installed
electrical outlet that matches the voltage and electrical
frequency stated on the pressure washer's rating plate.
► Switch on the pressure washer and let the pump run for up
to 30 seconds until the water flow stops. Remaining water
will be eliminated from the system.
► Switch off pressure washer and disconnect it from the
power supply.
NOTICE
Freezing temperatures can damage components of the
pressure washer. STIHL recommends storing the pressure
washer indoors in a dry room where it is protected from
freezing temperatures. Relieve all system pressure and
make sure all water is eliminated from the pump system and
hoses before storing.
Protecting the Pressure Washer with Antifreeze
WARNING
When using antifreeze to protect your pressure washer in
winter conditions, observe all warnings and instructions
provided by the manufacturer to reduce the risk of
environmental contamination or severe personal injury from
ingestion.
1
2
3
7
6
5
4
4
0000-GXX-6489-A0
8
8
8
0000-GXX-6406-A0
8
8