Instruction Manual

0458-814-8621-A
27
English 13 After Finishing Work
► If you want to remove dirt from painted, wooden or other
potentially sensitive surfaces, increase the distance
between the nozzle and the surface.
To adjust the fan jet nozzle:
WARNING
To reduce the risk of injury from high-pressure spray, always
switch off the pressure washer, relieve any remaining
pressure in the system and lock the spray gun trigger before
attempting to insert, adjust or remove the spray nozzle.
► Switch off the pressure washer.
► Relieve system pressure.
► Lock the spray gun trigger.
► Rotate the fan-jet nozzle in the (+) direction to increase
the working pressure.
► Rotate the fan-jet nozzle in the (-) direction to reduce the
working pressure.
To clean:
► Before starting work, direct the water jet at an
inconspicuous area of the surface and check that the
surface is not damaged.
► Work at a distance that allows you to effectively clean the
surface without damaging it.
► Adjust the fan-jet nozzle and distance from the surface to
be cleaned to ensure the surface will not be damaged by
the spray.
► Move the spray attachment evenly along the surface to be
cleaned.
► Move forward slowly in a controlled manner.
13.1 Preparing for Transportation or Storage
To prepare the pressure washer for transportation or
storage:
► Switch off the pressure washer, @ 11.2.
► Disconnect the pressure washer from the power supply.
► Disconnect the pressure washer from the water supply.
► Press the spray gun trigger to relieve any remaining
pressure in the system.
► Lock the spray gun trigger.
► Disconnect the water hose.
► Remove and clean the nozzle and spray lance.
► Remove the spray gun and let the rest of the water run out
of the spray gun.
► If the pressure washer will be exposed to freezing
temperatures, protect it with antifreeze or take other
measures outlined below, @ 13.2.
► Clean the pressure washer.
0000-GXX-4628-A0
13 After Finishing Work
0000-GXX-5094-A0