Instruction Manual
Table Of Contents
- 1 Introduction
- 2 Guide to Using this Manual
- 3 Main Parts
- 4 Safety Symbols on the Product
- 5 IMPORTANT SAFETY INSTRUCTIONS
- 6 Maintenance, Repair and Storage
- 7 Before Starting Work
- 8 Assembling the Pressure Washer
- 9 Connecting the Water Supply
- 10 Ground Fault Circuit Interruptor (GFCI)
- 11 Switching the Pressure Washer On and Off
- 12 During Operation
- 13 After Finishing Work
- 14 Transporting
- 15 Storing
- 16 Cleaning
- 17 Inspection and Maintenance
- 18 Troubleshooting Guide
- 19 Specifications
- 20 Replacement Parts and Equipment
- 21 Disposal
- 22 Limited Warranty
- 23 Trademarks
- 24 Addresses
- 1 Introducción
- 2 Acerca de este manual de instrucciones
- 3 Componentes importantes
- 4 Símbolos de seguridad en el producto
- 5 INSTRUCCIONES IMPORTANTES DE SEGURIDAD
- 6 Mantenimiento, reparación y almacenamiento
- 7 Antes de empezar a trabajar
- 8 Armado de la hidrolavadora
- 9 Conexión del suministro de agua
- 10 Interruptor de pérdidas a tierra (GFCI)
- 11 Encendido y apagado de la hidrolavadora
- 12 Durante el funcionamiento
- 13 Después de completar el trabajo
- 14 Transporte
- 15 Almacenamiento
- 16 Limpieza
- 17 Inspección y mantenimiento
- 18 Guía de solución de problemas
- 19 Especificaciones
- 20 Piezas y equipos de repuesto
- 21 Eliminación
- 22 Garantía limitada
- 23 Marcas comerciales
- 24 Direcciones
0458-814-8621-A
26
English
12 During Operation
Use the detergent spray set to add detergents:
► Always read and follow instructions provided by the
manufacturer of the detergent before starting work.
► STIHL recommends soaking surfaces with water before
applying detergent.
► Fill the detergent bottle (1) with up to 16.9 oz. (500 ml) of
detergent.
► Screw the detergent nozzle (2) onto the detergent bottle
and tighten firmly by hand.
► Attach the detergent spray set (4) to the spray lance (3).
► Spray the detergent onto the surface to be cleaned.
► When applying detergent, start at the bottom of the
surface and work upwards. Do not allow the detergent to
dry.
After applying detergent:
► Switch off the pressure washer, @ 11.2.
► Relieve system pressure.
► Lock the spray gun trigger.
► Remove the detergent spray set.
► Re-attach the fan-jet nozzle or rotary-jet nozzle.
► Spray the surface until it is clean and any remaining
detergent is washed away.
► When rinsing off detergent, start at the top of the surface
and work down.
12.3 Cleaning
WARNING
To reduce the risk of personal injury, never work with the
pressure washer in the rain, @ 5.5. Always wear proper
clothing and protective apparel, including proper eye
protection, when operating your pressure washer, @ 5.4.
Keep bystanders away from the work area, @ 5.8.4. Work
carefully and maintain proper control of the pressure
washer, @ 5.8.2.
WARNING
To reduce the risk of fluid injection and/or severe injury,
keep hands, feet and other parts of your body away from the
water jet at all times and never direct the high-pressure jet
toward yourself or other persons, not even to clean clothing
or shoes, @ 5.8.4. Do not direct the high-pressure jet
toward animals.
Depending on the application, the following nozzles may be
used:
– Fan-jet nozzle: The fan-jet nozzle is designed for cleaning
larger areas.
– Rotary-jet nozzle: The rotary nozzle is designed for
removing stubborn dirt.
► If you want to remove stubborn dirt, reduce the distance
between the nozzle and the surface.
0000-GXX-4345-A0
2
1
0000-GXX-5097-A0
4
3
500 ml
400 ml
300 ml
200 ml
100 ml