Instruction Manual

0458-616-0121-A
20
English 9 Connecting the pressure washer to the power supply
Connect the water filter
If the pressure washer is operated with water containing
sand from water butts, cisterns or from flowing or still rivers
and lakes, a water filter must be connected between the
water hose and the pressure washer.
Depending on the market, the water filter may be included
with the pressure washer.
► Unscrew connector (1).
► Screw water filter (2) onto the connector (3) and tighten by
hand.
Connect the water hose
► Fill the water hose (1) with water so that no air is present
in the water hose any more.
► Screw coupling (2) onto the connector of the water filter
(3) and tighten by hand.
► Attach suction cup (4) to the water source so that the
suction cup (4) does not touch the ground.
► If the spray gun is fitted to the high-pressure hose:
Remove spray gun.
► Hold high-pressure hose downwards.
► Switch on pressure washer until an even water jet flows
out of the high-pressure hose.
► Switch off pressure washer.
► Connect the spray gun to the high-pressure hose.
► Press and hold down spray gun trigger.
► Switch on pressure washer.
9.1 Connecting the pressure washer to an electric
power supply
► Set the toggle switch to the 0 position.
► Remove the connecting cord (2) from the holders (3).
► Plug the plug of the connecting cord into a correctly
installed socket.
2
3
1
0000-GXX-5302-A0
3
2
1
0000-GXX-5303-A0
1
4
9 Connecting the pressure washer to the
power supply
2
0000-GXX-5304-A0
1
3
3